|
Forums:
Climbing Disciplines:
Sport Climbing:
Re: [rannix] This look right?:
Edit Log
|
|
bearbreeder
Jan 25, 2012, 8:22 PM
Views: 11035
Registered: Feb 2, 2009
Posts: 1960
|
yr original setup will work fine ... my only suggestion would be to use all cloves instead of fig8s ... on dynamic rope cloves slipping shouldnt be an issue under a supervised belay ...and itll make it easier to set up and take down its actually a fairly common method to anchor in with the rope ... clove the rope to the 2 anchor biners, and then fig8/clove the loop between them as a masterpoint ... you can adjust the length away from the anchor by cloving in the master biner and adjusting slack out of the rope ... dont worry too much about what RCers say .. even if you made the "perfect" anchor theyd still tell you it sucks ... as said yr anchor is a fairly standard way of anchoring in with the rope on 2 pieces edit ... oh and DO clip into the anchor bolt at the belay with a separate draw ... what you DONT want is a fall off the belay without something in ....
(This post was edited by bearbreeder on Jan 25, 2012, 8:34 PM)
|
|
Edit Log:
|
Post edited by bearbreeder
() on Jan 25, 2012, 8:23 PM
|
Post edited by bearbreeder
() on Jan 25, 2012, 8:34 PM
|
|
|
|
|
|