|
|
Forums:
Climbing Disciplines:
Indoor Gyms:
Re: [sungam] Roof feature:
Edit Log
|
|
rschap
Jul 14, 2012, 5:03 PM
Views: 565
Registered: Sep 29, 2005
Posts: 590
|
This is on a horizontal roof.
Sure Magnus, the whole project was 2 sheets of plywood and like 5-6 eight ft long 2X4s (I didn’t count, I always have a stack of 2X4s laying around). I did the layout in Auto Cadd, I first drew it in 3D then took each triangle shaped side and layed it out on the 2 sheets of plywood. I cut all the sides with 90deg cuts then came back with a jig saw and ran it down the edge to cut the miter. I used 2X4s on the back side of all the seams for structure, cutting the angles into the 2X4s on a table saw. Everything is glued and screwed then I caulked any gaps in the seams. For paint I used “Deck Restore” which can be found at Home Depot, $40 for 2 gallons and a special roller, this job only took one gallon. The whole project took me 5 days but I was interrupted a lot so I probably could have done it in a lot less time.
(This post was edited by rschap on Jul 14, 2012, 5:27 PM)
|
|
Attachments:
|
Untitled.jpg
(38.1 KB)
|
|
|
flat layout.jpg
(84.2 KB)
|
|
|
photo (2) Small.jpg
(101 KB)
|
|
|
photo (1) small.jpg
(108 KB)
|
|
|
Edit Log:
|
|
Post edited by rschap
() on Jul 14, 2012, 5:05 PM
|
|
Post edited by rschap
() on Jul 14, 2012, 5:08 PM
|
|
Post edited by rschap
() on Jul 14, 2012, 5:08 PM
|
|
Post edited by rschap
() on Jul 14, 2012, 5:27 PM
|
|
|
|
|
|
