Forums: Climbing Information: The Lab: Re: [peretz87] cam design: Edit Log




patto


Aug 17, 2012, 1:07 AM

Views: 6007

Registered: Nov 14, 2005
Posts: 1451

Re: [peretz87] cam design
Report this Post
Average: avg_1 avg_2 avg_3 avg_4 avg_5 (0 ratings)  

peretz87 wrote:
No. It's not what i'm asking...
i'm not sure of the stresses in the lobe. don't know if there is bending stress, maybe torsion stress, maybe shear.

peretz87 wrote:
I don't know if there is shear stress and torsion stress on the lobe. When i will know what stresses there is on the lobe i will calculate them...
I think the force from the axle and from the wall apply compression and bensing stresses but maybe more stresses the i can miss.
How can you be confident knowing how to calculate stresses without even knowing whether they exist or not.

It is quite clearly that you have little understanding of how cams operate and how to resolve forces adequately.

This is all engineering 101. If you can't figure this out then are you really doing the right course?


The basic analysis of an SLCD is relatively easy and you can have a look at a comprehensive variety of stresses, shear, compression, tension. Buckling can also come into it too. But all this your should be able work out yourself.


(This post was edited by patto on Aug 17, 2012, 1:15 AM)



Edit Log:
Post edited by patto () on Aug 17, 2012, 1:15 AM


Search for (options)

Log In:

Username:
Password: Remember me:

Go Register
Go Lost Password?