|
|
Forums:
Climbing Information:
Gear Heads:
Charging Batteries in Sequence for Drill, Connector Question:
Edit Log
|
|
jsunmatthews
Feb 10, 2013, 6:04 PM
Views: 691
Registered: Nov 18, 2005
Posts: 87
|
I just picked up an old beast of a 24V Panasonic rotary hammer drill. I'm all good on the battery front with two marine 12V's wired in sequence, but I was wondering if anyone has thoughts on the best way to make a quick connect for the plug. I obviously need to be able to charge each battery independently, yes? So I need to disconnect the sequence for charging and then be able to reconnect to the drill once both batteries are charged. Those of you who know what I am talking about, what connection procedure do you normally use for charging when using this type of sequence model? I can cave man it (just strip the wire cap connections each time) but is there a cleaner approach? Appreciate it.
(This post was edited by jsunmatthews on Feb 10, 2013, 6:06 PM)
|
|
|
Edit Log:
|
|
Post edited by jsunmatthews
() on Feb 10, 2013, 6:06 PM
|
|
|
|
|
|
