Forums: Climbing Information: General: Re: [ARMClimbing] Top Rope Anchor setup: Edit Log




shockabuku


Apr 20, 2013, 10:31 AM

Views: 4428

Registered: May 20, 2006
Posts: 4856

Re: [ARMClimbing] Top Rope Anchor setup
Report this Post
Average: avg_1 avg_2 avg_3 avg_4 avg_5 (0 ratings)  

ARMClimbing wrote:
The most comon top rope set up when you have two bolts, either parallel o one higher than the other is to pass through some webbing, make a loop and then tie an overhand in the direction of the pull. My question is that if it would be ok to do the following: I have alot of old rope. I would take a 3 or 4 ft peace of old rope and tie double overhands to each extremity for bolt conection and then use a clove hitch with two opposing biners in the direction of the pull. Strength and security wise, would this be ok?

Do you drive on tires with no tread?

Would it be okay, in a pinch, - probably - but I wouldn't use it and I probably wouldn't climb with someone who did.

Figure eight or the overhand would be a better choice in all locations, especially if you're going to use it repeatedly. If you have a lot of old rope, don't be cheap with it.


(This post was edited by shockabuku on Apr 20, 2013, 10:32 AM)



Edit Log:
Post edited by shockabuku () on Apr 20, 2013, 10:32 AM


Search for (options)

Log In:

Username:
Password: Remember me:

Go Register
Go Lost Password?
$14.36 (10% off)
$80.06 (10% off)
$26.96 (10% off)
$3.56 (10% off)