May 26, 2013, 3:02 PM
Registered: Jul 17, 2010
I just spent a few minutes trying this and the usual back packer coil works when you single strand butterfly the rope just like when you double strand butterfly the rope.
On one end of the rope, set aside your usual length of rope used to tie the backpacker coil (for me that is about 2 full arm spans). Single butterfly coil the rope and when you get to the other end of the rope and have approx. the same length of rope tail as the front end, place them on the same side of the butterfly coil and tie off the back packer setup as usual.
When untying this set up, just identify the "top" and "bottom" ends and it should be ready to climb without re-flaking.
(This post was edited by MFC on May 26, 2013, 3:05 PM)