|
LineoFire
Jul 22, 2012, 2:36 PM
Post #1 of 4
(2329 views)
Shortcut
Registered: Aug 24, 2007
Posts: 22
|
Does any one have a method for cutting the new Sterling Powercord? Using a traditional hot knife only sees the sheath cutting while the core seems to smolder. I'm pretty sure that the heat resistance of the core materials is intensely high so finding a way to close off the cut so that the core strands are not exposed has been difficult. Any thoughts?
|
|
|
|
|
avalon420
Jul 22, 2012, 7:44 PM
Post #2 of 4
(2277 views)
Shortcut
Registered: Mar 1, 2005
Posts: 281
|
I use a little super glue
|
|
|
|
|
sbaclimber
Jul 23, 2012, 7:25 AM
Post #3 of 4
(2212 views)
Shortcut
Registered: Jan 22, 2004
Posts: 3118
|
You have to cut the core (not easy either, best using a razor knife against a cutting board), pull the ends of the sheath a bit out beyond the ends of the core, and then melt the ends of the sheath closed.
|
|
|
|
|
Rudmin
Jul 23, 2012, 2:03 PM
Post #4 of 4
(2174 views)
Shortcut
Registered: Mar 29, 2009
Posts: 606
|
Wrap the whole thing tightly with electrical tape, then put it under a little tension and cut through the middle of the tape with a sharp knife or scissors. Seal the sheath over the core with a lighter or other heat source.
|
|
|
|
|
|