|
Gdog42
Apr 24, 2013, 10:33 PM
Post #1 of 3
(2261 views)
Shortcut
Registered: Apr 18, 2013
Posts: 30
|
I recently bought a 5m length of pre-cut cord so I can use it specifically for prusiks/autoblocks. I will not be using it for anchors (I prefer slings for that!) The diameter is 7mm, which I know is suitable for this purpose but the strength rating is 9.8 kN I've previously used cords for multiple purposes that are stronger than this (10-12 kN range), but since falling with a prusik on the rope wouldn't result in a high-impact force, do you think 9.8 kN should be ok if this is all I'm using it for?
(This post was edited by Gdog42 on Apr 24, 2013, 10:36 PM)
|
|
|
|
|
redlude97
Apr 24, 2013, 10:50 PM
Post #2 of 3
(2248 views)
Shortcut
Registered: Aug 27, 2008
Posts: 990
|
form a loop and it doubles the strength minus the knot. Its fine. 6mm is fine.
|
|
|
|
|
moose_droppings
Apr 24, 2013, 10:58 PM
Post #3 of 3
(2246 views)
Shortcut
Registered: Jun 7, 2005
Posts: 3371
|
Gdog42 wrote: I recently bought a 5m length of pre-cut cord so I can use it specifically for prusiks/autoblocks. I will not be using it for anchors (I prefer slings for that!) The diameter is 7mm, which I know is suitable for this purpose but the strength rating is 9.8 kN I've previously used cords for multiple purposes that are stronger than this (10-12 kN range), but since falling with a prusik on the rope wouldn't result in a high-impact force, do you think 9.8 kN should be ok if this is all I'm using it for? If your just using it for a prusik (rope grab) then weight isn't as important as size. You'll want a cord size that is around 3mm smaller than the cord/rope your using it on. The larger difference in size the less raps you'll need for it to be efficient. BTW, 7mm cord is plenty strong enough for anchors especially when looped which doubles it's strength minus the loss for the knot.
(This post was edited by moose_droppings on Apr 24, 2013, 11:01 PM)
|
|
|
|
|
|
|
|
|