|
wolfeman
Aug 9, 2006, 2:55 AM
Post #1 of 4
(830 views)
Shortcut
Registered: Aug 31, 2003
Posts: 78
|
Need some badly for the next BIG THING.
Please let me know if you have some to sell, or know where to get them.
Thanks, Erik
|
|
|
|
|
socalbolter
Aug 9, 2006, 3:30 AM
Post #2 of 4
(830 views)
Shortcut
Registered: Mar 27, 2002
Posts: 796
|
If you can't find any you could get all techy and use a 3/8" hanger:
Go to your local high-end industrial hardware supply and buy some 3/8" outside diameter by 1/4" inside diameter by 1/8" thick stainless bushings. These will insert into the 3/8" hole and allow for a centered fit with 1/4" bolts. You would also need to get some stainless 1/4" washers or fender washers to span over the oversized 3/8" hole in the hanger.
This may seem like a lot of work, but 3/8" hangers are readily available and they (along with these added pieces) would likely still be cheaper than 1/4" hangers (if you can find them).
Not the perfect solution, but it would work.
Happy hunting!
|
|
|
|
|
tattooed_climber
Aug 9, 2006, 4:07 AM
Post #3 of 4
(830 views)
Shortcut
Registered: Dec 13, 2003
Posts: 4838
|
bellingham?>??
pfffft....drive up to vancouver and go to MEC....the exchange is in your favor
MEC sells Pika 1/4" hangers and pika 1/4" removeable hangers
they don't have them on their website but they still sell em
|
|
|
|
|
wolfeman
Aug 9, 2006, 4:18 AM
Post #4 of 4
(830 views)
Shortcut
Registered: Aug 31, 2003
Posts: 78
|
Thanks for the good beta, Guys.
I checked MEC's website before i posted and didn't see the hangers, so bueno. I will check it out next week in person.
The bushing idea is great, I was worried about just using the washers on the 3/8" hangers, shock-load and all.
The rock is really bullet.
|
|
|
|
|
|
