p8ntballsk8r wrote:
There is a route I'm projecting that has a 4ft roof on it. After clipping the bolt below the roof and then continuing the route, the rope rubs against an edge that is sharp. How would I extend this quickdraw placement so there would be both less rope drag and this sharp edge would not be a factor.
I'm planning on using a runner, but I'm not quite sure how one would set that up. Would it be: quickdraw into a bolt, runner into the quickdraw, then another quickdraw? Is there an easier way to do this that does not require two quickdraws? Also is this a safe way of handling the situation or is there a better way to go about it?
Finally, could accessory cord, say a prussik loop be used in place of a runner? Or would that be a bad idea?